Download Print this page

Cisco DFC3B Installation Note page 36

Distributed forwarding card 3 for ws-x67xx modules
Hide thumbs Also See for DFC3B:

Advertisement

Removing and Installing Ethernet Modules in the Chassis
Fully open both ejector levers on the Ethernet module. (See
Step 3
Depending on the orientation of the slots in the chassis (horizontal or vertical), perform one of the
Step 4
following two sets of substeps:
Horizontal slots
Position the Ethernet module in the slot. (See
a.
module carrier with the slot guides on each side of the slot.
Carefully slide the Ethernet module into the slot until the EMI gasket along the top edge of the
b.
module makes contact with the module in the slot above it and both ejector levers have engaged and
closed to approximately 45 degrees with respect to the Ethernet module faceplate. (See
Using the thumb and forefinger of each hand, grasp the two ejector levers and press down to create
c.
a small (0.040 inch [1 mm]) gap between the module's EMI gasket and the module above it. (See
Figure
Do not press down too hard on the levers because they can bend and be damaged.
Caution
While gently pressing down, simultaneously close the left and right ejector levers to fully seat the
d.
Ethernet module in the chassis backplane connector. The ejector levers are fully closed when they
are flush with the module faceplate. (See
Note
Tighten the two captive installation screws on the Ethernet module.
e.
Note
Verify that the Ethernet module STATUS LED is lit. Check the STATUS LED periodically. If the
f.
STATUS LED changes from orange to green, the module has successfully completed the boot
process and is now online. If the STATUS LED remains orange or turns red, the module has not
successfully completed the boot process and may have encountered an error.
Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note
36
26.)
Failure to fully seat the module in the chassis backplane connector can result in error
messages.
Make sure that the ejector levers are fully closed before tightening the captive installation
screws.
Figure
25.)
Figure
25.) Make sure that you align the edges of the
Figure
27.)
Figure
26.)
78-15893-08

Advertisement

loading

This manual is also suitable for:

Dfc3aDfc3bxlCatalyst 6500 series