Advertisement
Installing the DFC3B and DFC3C Daughter Cards
Figure 17
Apply pressure here to seat power connector
Caution
Use care not to damage the connectors on the module. If you damage a connector, you will need to return
the module to Cisco for repair.
Position the installation bracket over the two male standoffs at the back of the DFC daughter card. Apply
Step 6
pressure only to the top of the bracket to fully seat the DFC3 daughter card on the module as shown in
Figure
When seating the DFC daughter card, do not apply pressure to any other location on the DFC daughter
Caution
card, especially the heat sinks. If you exert pressure on the heat sinks, they can break off of the
components they are attached to.
Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note
26
Seating the Power Connector
WS-X5530
18.
78-15893-08
Advertisement
