Cisco DFC3B Installation Note page 20

Upgrading the Ethernet Module Memory
Removing the Memory Module
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
Warning
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
To remove the existing memory module from the Ethernet module, follow these steps:
Attach an ESD grounding strap to your wrist and to ground.
Step 1
If you are unsure about the correct way to attach an ESD grounding strap, refer to the
ESD Grounding Strap" section on page 42
Locate the memory module on the Ethernet module. (See
Step 2
Figure 10
Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note
20
Location of the Memory Module on a WS-X67xx Module
WS-X5530
for instructions.
Figure 10.)
"Attaching Your
DDR SDRAM
SODIMM
78-15893-08