Advertisement
Figure 24
You must install all of the installation hardware. The screws provide grounding between the DFC3
Caution
daughter card and the module. Failure to install all of the screws invalidates the safety approvals and
presents a risk of fire and electrical hazard.
Step 10
Reinstall the Ethernet module in the chassis.
If you are unsure about the correct procedure for installing the Ethernet module in the switch chassis,
refer to the
instructions.
78-15893-08
Installing the DFC3C and DFC3CXL Installation Hardware (WS-X6748-GE-TX Equipped
with a Front Stiffener Bracket)
Stiffener bracket tabs. DFC
daughter card must be installed
underneath tabs.
"Installing an Ethernet Module in the Chassis" section on page 35
Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note
Installing the DFC3B and DFC3C Daughter Cards
Installation
bracket
for installation
33
Advertisement
