Automatic Operation - laguna Plasma Level 2 CNC Owner's Manual

24.) SAVING AND EDITING FILES (Cont'd.)-
After entering the value, it is a good idea to run a test square (approximately 4" square) and
measure the size of the part. If it is undersize, then the kerf value is too small, and the operator
should add to it. If it is oversize, then the kerf value is too large, and the operator should subtract
from it.

25.) AUTOMATIC OPERATION-

Prior to cutting the part, it may be desired to test run the program without cutting. See the
section on "TEST MODE (DRY RUN)" to test run the program. Pressing the
"Green CYCLE START Button" at this point will start the program execution.
96