laguna Plasma Level 2 CNC Owner's Manual page 23

HOT SURFACES(Cont'd.)-
NOTE: Be sure to use an approved facemask and approved eye protection when cleaning or
servicing the dust collector.
NOTE: Plasma arc cutting systems can produce large volumes of fumes. If you exhaust fumes to
the outside atmosphere, additional air pollution control devices may be to conform to local, state,
and federal government ordinances. Air pollution control devices are the responsibility of each
individual user.
Internal Ventilation System-
Due to the noxious and toxic nature of many torch cutting by-products, Phoenix recommends
venting the machine's internal ventilation system (referred to as the "dust collector") to the
outside atmosphere. This recommendation is especially important when the shop has one of the
following:
1.) Low Ceilings and/or confined area.
2. Large amount of Welding and/or Torch Cutting near the Plasma System.
3. Poor Cross Plant Ventilation.
23