laguna Plasma Level 2 CNC Owner's Manual page 60

20.3.) Shielding (Other):
• If cables must cross ground wires or at worse case torch leads do so at 90-degree angles.
• Select a power outlet rated to support the devices that will be connected.
• Avoid connecting the cutting table to multiple AC power outlets. Use one outlet with a
good surge suppression device and multiple power outlets.
• The Plasma Power Supply may be connected to a different power outlet however it is
best if the outlet is common to the same panel as the cutting table.
• Do not coil wires and cables. If you need to clean up the install do so by wire tying the
loops of extra cable, so the major length of the cable is touching.
Remove as much air gap as possible from the cable bunch.
See Below Figure-
60