Perkins 1104D Operation And Maintenance Manual page 94

94
Maintenance Section
Fuel System Primary Filter (Water Separator) Element - Replace
Illustration 60
7. Use a suitable tool in order to remove old canister
(4).
g01429126 Illustration 61
8. Lubricate O ring seal (5 ) with clean engine oil on
the new canister. Install new canister (6). Spin on
the canister until the O ring seal contacts the
sealing surface. Then rotate the canister 360
degree in order to tighten the canister correctly.
9. Remove cap (8) from the threaded end of the new
canister and remove new O ring seal (7). Install
the new O ring seal into bowl (3).
10. Lubricate O ring seal (7) with clean engine oil.
Install the bowl onto the new canister. Tighten the
bowl to 15 N·m (11 lb ft).
11. If equipped, install the wiring harness to the
sensor. Open the fuel supply valve.
12. Remove the container and dispose of the fluid in
a safe place.
SEBU8172-04
g01429127