Perkins 1104D Operation And Maintenance Manual page 87

SEBU8172-04
Illustration 49
Typical example
3. Clean the sealing surface of the oil filter head (2).
Ensure that the union is secure in the filter head.
4. Apply clean engine oil to the O ring seal (3) for the
new oil filter.
NOTICE
Do not fill the oil filters with oil before installing them.
This oil would not be filtered and could be contami-
nated. Contaminated oil can cause accelerated wear
to engine components.
5. Install the oil filter. Tighten the oil filter to 12 N·m
(8.8 lb ft). Do not overtighten the oil filter.
Horizontal Oil Filter
g01187802
Illustration 50
Typical example
Note: Some oil filters may be installed horizontally.
Refer to illustration 50 . This type of oil filter assembly
can be drained before the filter is removed. Start at
step 1 in order to remove the oil filter and install the
oil filter.
Fill the Oil Pan
1. Remove the oil filler cap. Refer to this Operation
and Maintenance Manual, "Fluid
Recommendations" for more information on
suitable oils. Fill the oil pan with the correct
amount of new engine lubricating oil. Refer to this
Operation and Maintenance Manual, "Refill
Capacities" for more information on refill
capacities.
If equipped with an auxilliary oil filter system or a re-
mote filter system, follow the OEM or the filter manu-
facture's remonmendations. Under filling or over
filling the crankcase with oil can cause engine
damage.
Maintenance Section
Engine Oil and Filter - Change
g01428535
NOTICE
87