Installing Adapters in the WAE-7371, WAE-7341, and WAE-674 Appliances
Install the adapter, as shown in
Step 7
Figure 17
Connect any needed cables to the adapter.
Step 8
Caution
When you route cables, do not block any connectors or the ventilated space around any of the fans.
Make sure that cables are not routed on top of components under the PCI-X riser-card assembly.
Make sure that cables are not pinched by the device components.
Carefully align the riser-card assembly with the release tab posts, the guides on the rear of the WAE, and
Step 9
the riser-card connector on the system board. Press down on the assembly. (See
that the riser-card assembly is fully seated in the riser-card connector on the system board.
Installing the Cisco WAE Inline Network Adapter
24
Figure
17. The riser-card assembly is shown inverted in
Installing the Adapter in the Riser-Card Assembly
Inverted riser assembly
Figure
17.
Figure
18.) Make sure
OL-12480-03