Cisco Wide Area Application Engine WAE-674-K9 Installation Manual page 21

Completing the Installation
To complete your installation, reinstall the cover, and reconnect all cables that you disconnected earlier.
To maintain proper cooling and airflow, install the cover before turning on the appliance. Operating the
Caution
appliance for extended periods (over 30 minutes) with the cover removed might damage internal
components.
To install the cover, follow these steps:
Step 1 Place the cover release latch (labeled 1 in
Step 2 Insert the bottom tabs of the top cover into the matching slots in the device chassis.
Press down on the cover release latch to lock the cover in place.
Step 3
Figure 14
Install the appliance in the rack.
Step 4
Connect all external cables and the power cord to the appliance, and then plug the power cord into a
Step 5
properly grounded electrical outlet.
OL-12480-03
Figure
Installing the Cover
1
Installing Adapters in the WAE-7326 Appliance
14) in the open (up) position.
Installing the Cisco WAE Inline Network Adapter
21