Cisco Wide Area Application Engine WAE-674-K9 Installation Manual page 18

Installing Adapters in the WAE-7326 Appliance
Removing the Cover
Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord.
Warning
Statement 1
To remove the device top cover, follow these steps:
Review the information in the
Step 1
Power off the device and all attached devices and disconnect all external cables and power cords.
Step 2
Step 3 Press down on the left and right side latches and pull the device out of the rack enclosure until both slide
rails lock.
Note
Step 4 Lift the cover-release latch (labeled 1 in
Figure 11
For proper cooling and airflow, replace the cover before turning on the device. Operating the device for
Caution
extended periods (over 30 minutes) with the cover removed might damage device components.
Installing the Cisco WAE Inline Network Adapter
18
"Safety Guidelines" section on page
You can reach the cables on the back of the device when the device is in the locked position.
Removing the Cover
Figure 11). Lift the cover off the device and set the cover aside.
1
5.
OL-12480-03