Cisco Wide Area Application Engine WAE-674-K9 Installation Manual page 11

Figure 5
1
Riser card
3 PCI-X slot 1 connector
5 Adapter
Step 7 Touch the static-protective package that contains the adapter to any unpainted metal surface on the
appliance, and then remove the adapter from the static-protective package. Avoid touching the
components and gold-plated edge connectors on the adapter.
Place the adapter, component-side up, on a flat, static-protective surface and set any jumpers or switches
Step 8
as described by the adapter manufacturer, if necessary.
When you install an adapter in the appliance, be sure that it is completely and correctly seated in the PCI
Caution
expansion slot before you power up the appliance. Incomplete insertion might cause damage to the
system board or the adapter.
Step 9 To install the adapter, carefully grasp the adapter by its top edge or upper corners, align it with the PCI-X
slot 1 connector (labeled 3 in
OL-12480-03
Installing an Adapter in the Riser Card Assembly
1 2
6
Figure 5), and then press the adapter firmly into the expansion slot.
Installing Adapters in the FE-511, WAE-511, and WAE-611 Appliances
3 4
5
2
PCI-X slot 2 connector
4 Adapter support bracket
6 PCI-X riser card connector
Installing the Cisco WAE Inline Network Adapter
11