Cisco Wide Area Application Engine WAE-674-K9 Installation Manual page 16

Installing Adapters in the WAE-512 and WAE-612 Appliances
Figure 9
1 Expansion slot bracket
3
Adapter support bracket
5
Riser card assembly
7 Riser card connectors
Touch the static-protective package that contains the adapter to any unpainted metal surface on the
Step 8
device, and then remove the adapter from the static-protective package. Avoid touching the components
and gold-plated edge connectors on the adapter.
Place the adapter, component-side up, on a flat, static-protective surface.
Step 9
When you install an adapter in the device, be sure that it is completely and correctly seated in the PCI
Caution
expansion slot before you power up the device. Incomplete insertion might cause damage to the system
board or the adapter.
Step 10 To install the adapter, carefully grasp the adapter by its top edge or upper corners, align it with the
expansion slot in the riser card assembly, and then press the adapter firmly into the expansion slot.
Reinstall the riser card. Make sure that the riser card is fully seated in the riser card connectors on the
Step 11
system board.
Installing the Cisco WAE Inline Network Adapter
16
Installing the Adapter in the Riser Card Assembly
2
1
3
4
5
6
7
2 Adapter
4
PCI-X expansion slot 1
6
PCI-X expansion slot 2 (not supported)
OL-12480-03