Table of Contents
Advertisement
Operation
Manual Operation
Remote control unit
TEMP
ON
OFF
SWING
1
MODE
SLEEP
HEALTH
FRESH
CLOCK
SET
3
TIMER
HIGH/SO
2
FILTER
LIGHT
LOCK
RESET
CODE
Note:
After setting TIMER function, the remote controller displays TIMER time. If you want to see clock time,
just press CLOCK button once: clock time will be displayed (if you press the button again continuously,you
can adjust clock). 5 seconds later, the display will show TIMER time again.
3
2
TIMER
TIME
TIME
CLOCK
SET
SLEEP
4
Set clock correctly before starting TIMER operation
1.Unit start
After unit start, select your desired operation mode (operation
mode will be displayed on LCD)
2.TIMER mode selection
A
Press TIMER button on the remote controller to change TIMER
mode. Every time the button is pressed, display of TIMER mode
changes as follows:
TIMER ON TIMER OFF
Then select TIMER mode as needed (TIMER ON or TIMER OFF).
Now
FAN
3.TIMER setting (press time adjust buttons
Every time the button is pressed, time increases 10 minuts.
If the button is kept pressed, time changes quickly.
Every time the button is pressed, time decreases 10 minuts.
If the button is kept pressed, time changes quickly.
It can be adjusted within 24 hours at will.
4
4.Confirm setting
After setting correct time, press SET button to confirm time. Now
or
ON
Time displayed: unit starts or stops at X hour X min (TIMER ON
or TIMER OFF)
5.Cancel TIMER mode
Just press TIMER button several times until TIMER mode
disappears.
Hints:
After replacing batteries or if a power failure occurs, TIMER setting
must be reset.
Remote controller has memory function. When you use TIMER
mode next time, just press SET button after mode selection if timer
setting is the same as the previous one.
AM
:
TIMER ON
ROOM
TEMP
AM
:
LOW MED HIGH
ON
OFF
12:00
12:00
AM
PM
or
will flash.
OFF
ON
stop flashing.
OFF
10
Timer ON/OFF Function
MODE
TEMP
C
TEMP
FAN SPEED
SWING
blank
ON
OFF
12:00
12:00
AM
PM
TIMER ON-OFF
ON
OFF
1
)
Advertisement
Table of Contents
