Remote Control - Haier HPRB08XCM User Manual

Operation
Remote Control
Haier
Power Control
The power control turns the unit on and off.
Mode Control
There are 3 models of Operations: "Cool" (When
unit is cooling), "Dehumidify", and "Fan" (only Fan
running). A mode Indicator light on the unit control
panel shows the following colors: Blue for "Cool"
mode; Orange for "Dehumidify", and Green for
"Fan".
The unit will start in "Cool" mode with a Blue
Indicator light. Once you press the "Mode" button
on the remote, it will change to "Dehumidify" mode.
Press the "Mode" button again to get "Fan" mode.
It goes back to the "Cool" mode once the "Mode"
button is pressed again.
Note: When you press "Up" and "Down" buttons
and there is no response, please press the "Mode"
button until the unit indicator light is Blue ("Cool"),
you can then adjust the temperature accordingly.
• Cooling Mode
During the cooling mode the air is cooled and
hot air is exhausted to the outside air through
the air exhaust hose. Adjust fan speed and
temperature to suit your desired comfort level.
Note: The air exchange hoses must vent
outside the room when using Cool Mode.
English
• Dehumidify Mode
Air is dehumidified as it passes through air
conditioner, without being in full cooling mode.
If room temperature is greater than 77°F, fan
speed can be adjusted; otherwise fan speed is
fixed to "low."
+ Fan Mode
Air is circulating throughout the room with no
cooling.
Note: Unit does not need to be vented in
Fan Mode.
Fan Speed Control
The Fan Speed Control has 3 settings:
High, Medium and Low.
Temp Set Controls
Press "Up" or "Down" to set temperature. The
setting range is from 61°F to 89°F.
Note: When using Dehumidify or Fan Mode,
temperature setting button is invalid.
Timer Setting Control
+ When you use the timer setting button while the
unit is operating, you can preset a time for the
unit to turn off.
* When you use the timer setting button while the
unit is on standby, you can present a time for
the unit to turn on.
• If you press the "ON/OFF" button, the preset
timer function will be cancelled.
© Timer setting range is 1-24 hours.