Remote Control Features And Settings - Haier WJ01X24721 Owner's Manual

REMOTE CONTROL FEATURES AND SETTINGS

7
8
2
3
10
9
16
12
17
13
1. Power Button
Press the ON/OFF button on the remote control to start
or stop the unit.
2. COOL Button
In COOL mode, the unit operates in cooling. When FAN is
set to AUTO, the heat pump automatically adjusts the fan
speed according to the room temperature. The
displayed during COOL mode.
3. HEAT Button
In HEAT mode, warm air will blow out after a short period
of the time due to cold-air prevention function. When
FAN is set to AUTO, the heat pump automatically adjusts
the fan speed according to room temperature. The
be displayed during HEAT mode.
49-5000786 Rev. 0
4. Temperature +/- Buttons
Temp + : Every time the button is pressed, the
temperature setting increases. Temp - : Every time the
button is pressed, temperature setting decreases. The
operating temperature range is 60°F-86°F (16°C-30°C).
5. FAN SPEED Button
FAN SPEED: For each press the fan speed changes as
follows:
Remote control:
1
6. DRY Button
DRY mode is used to reduce humidity. In DRY mode, when
room temperature becomes lower than temp setting
6
+2°F, unit will run intermittently at LOW speed regardless
of FAN setting. The
4
7. FAN MODE Button
FAN mode circulates air only; there is no temperature
adjustment available. Use the fan speed button (5) to
11
adjust fan speed from low, medium to high. Auto, Turbo
and Quiet are not available.
8. TURBO Button
5
The TURBO function is used for fastest air flow in Heating
or Cooling modes. Control will display the TURBO
on the bottom right side of the remote display. Pressing
14
the TURBO button again or the FAN SPEED button will
turn TURBO off.
15
9. Quiet Button
19 The QUIET function switches the fan to the lowest speed.
The control will display the QUIET
left side of the remote display. Pressing the QUIET button
18
again or the FAN SPEED button will turn QUIET off.
10. Louver UP/DOWN Button
Press the LOUVER UP/DOWN button to choose the
position of the horizontal airflow louvers. Status display
of air flow
COOL/DRY
HEAT
will be
NOTE:
• It is advisable not to keep the vertical louver in the
downward position for an extended period of time in
COOL or DRY mode, otherwise condensate water may
form on the louver.
• When turning the unit on, the remote control will
will
automatically return the louver to the previous set swing
position. When turning the unit off, the louver will rotate to
the full open position prior to closing.
LOW MED HI
will be displayed during DRY mode.
Auto
Auto
Display
circulated
AUTO
5