Remote Control Unit - Haier HPU-48HV03 Operation And Installation Manual

Operation
Manual Operation

Remote control unit

ON
TEMP
ON
OFF
FAN
HEALTH
1
MODE
1
SLEEP SWING
CLOCK SET
1
TIMER
HEAT
3
RESET LIGHT LOCK
Note:
After setting TIMER function, the remote controller displays TIMER time.
ON/OFF MODE FAN
Set clock correctly before starting TIMER operation
1.Unit start
After unit start, select your desired operation mode (operation
mode will be displayed on LCD)
2.TIMER mode selection
Press TIMER button on the remote controller to change TIMER
mode. Every time the button is pressed, display of TIMER mode
changes as follows:
ON OFF
12:00
AM
PM
TIMER ON TIMER OFF
Then select TIMER mode as needed (TIMER ON or TIMER OFF).
Now or
ON OFF
3.TIMER setting (press time adjust buttons
Every time the button is pressed, time increases 1 minuts.
If the button is kept pressed, time changes quickly.
Every time the button is pressed, time decreases 1 minuts.
If the button is kept pressed, time changes quickly.
It can be adjusted within 24 hours at will.
4.Confirm setting
After setting correct time, press SET button to confirm time. Now
or stop flashing.
ON OFF
The control panel will display TIMER.
5.Cancel TIMER mode
Just press TIMER button several times until TIMER mode
disappears.
Hints:
After replacing batteries or if a power failure occurs, TIMER setting
must be reset.
Remote controller has memory function. When you use TIMER
mode next time, just press SET button after mode selection if timer
setting is the same as the previous one.
10
Timer ON/OFF Function
TIMER
TEMP
ON OFF
12:00 12:00 12:00
AM
PM
TIMER ON-OFF
will flash.
TEMP TEMP HEALTH
blank
)