Cisco AS5400 Quick Start Manual page 52

Enter global configuration mode. You are in global configuration mode when the prompt changes to
Step 2
Gateway# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Gateway(config)#
Step 3 Specify the country to set the DFC parameters (including country code and encoding). This setting is applied at the
system level. All DFCs use the same country code. The default is usa if the gateway is configured with T1 interfaces and
e1-default if the gateway is configured with E1 interfaces. Use the no form of this command to set the country code to
the default of domestic.
Note All sessions on all DFCs in all slots must be idle for this command to run.
Gateway(config)# spe country country name
Enter the numbers of the ports to configure. If you want to configure 108 ports on slot 3, enter line 3/00 3/107. If you
Step 4
want to configure 324 ports on slots 3-5, enter line 3/00 5/107.
Gateway(config)# line slot/port slot/port
Gateway(config-line)#
Allow all protocols to be used when connecting to the line:
Step 5
Gateway(config-line)# transport input all
Enable remote IP users running a PPP application to dial in, bypass the EXEC facility, and connect directly to the
Step 6
network:
Gateway(config-line)# autoselect ppp
Enable incoming and outgoing calls:
Step 7
Gateway(config-line)# modem inout
Return to privileged EXEC mode:
Step 8
Gateway(config-line)# Ctrl-Z
Gateway#
Tip To save the gateway configuration, save it to NVRAM. Refer to the "Saving Configuration Changes" section on
page 57.
Verify
To verify your SPE configuration:
• To display a summary for all the lines, enter the show spe command:
Gateway# show spe
SPE settings:
==============
Country code configuration: default T1 (u Law)
Polling interval: 8 secs.
History log events: 50(per port)
Port legends:
============
Port state: (s)shutdown (t)test (r)recovery (d)download
(b)busiedout (p)busyout pending, (B)bad (a)active call
Call type: (m)modem (d)digital (f)fax-relay (v)voice (_)not in use
System resources summary:
======================
52
Gateway(config)#.