Cisco AS5400 Quick Start Manual page 33

Basic management setup configures only enough connectivity for management of the system. Extended setup will ask
you to configure each interface on the system.
Would you like to enter basic management setup? [yes/no]: no
Step 3 When the following message appears, press Return to see the current interface summary:
First, would you like to see the current interface summary? [yes]:
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
Async1/00 unassigned
Async1/01 unassigned
.
.
.
FastEthernet0/0 unassigned
FastEthernet0/1 unassigned
Group-Async0 unassigned
Serial0/0 unassigned
Serial0/1 unassigned
Enter a host name for the gateway:
Step 4
Configuring global parameters:
Enter host name [Router]: Gateway
Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when viewing the
Step 5
configuration.
The enable secret is a password used to protect access to privileged EXEC and configuration modes. This
password, after entered, becomes encrypted in the configuration.
Enter enable secret: xxxx
Enter an enable password that is different from the enable secret password. This password is not encrypted (less secure)
Step 6
and can be seen when viewing the configuration.
The enable password is used when you do not specify an enable secret password, with some older software
versions, and some boot images.
Enter enable password: guessme
Enter the virtual terminal password, which prevents unauthenticated access to the universal gateway through ports
Step 7
other than the console port:
The virtual terminal password is used to protect access to the router over a network interface.
Enter virtual terminal password: guessagain
Respond to the following prompts as appropriate for your network:
Step 8
Configure System Management [yes/no] no
Configure SNMP Network Management? [yes]:
Community string [public]:
Configure LAT? [yes]: no
Configure AppleTalk? [no]:
Configure DECnet? [no]:
Configure IP? [no]: yes
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [1]:
Configure CLNS? [no]:
Configure IPX? [no]:
Configure Vines? [no]:
Configure XNS? [no]:
Configure Apollo? [no]:
Configure bridging? [no]:
IP-Address OK? Method Status
NO unset
NO unset
NO unset
NO unset
NO unset
NO unset
NO unset
Protocol
up up
up up
up up
up up
up up
up down
up down
33