Cisco AS5400 Quick Start Manual page 46

Cisco systems universal gateway quick start guide
Table of Contents

Advertisement

For CE1 ISDN PRI—If you do not specify the time slots, the specified controller is configured for 30 B channels and
Note
1 D channel. B channel numbers range 1 to 31; channel 16 is the D channel for E1. Corresponding serial interface
numbers range 0 to 30. In commands, the D channel is interface serial
Return to privileged EXEC mode:
Step 6
Gateway(config-controller)# Ctrl-Z
Gateway#
To save the gateway configuration, save it to NVRAM. Refer to the "Saving Configuration Changes" section on
Tip
page 57.
Verify
To verify that you have configured the interfaces correctly:
• Enter the show controller t3 command and specify the slot and port numbers. Verify that the controller is up and that you
do not have excessive errors; otherwise, your controller might go down frequently. This could indicate switch problems.
Gateway# show controller t3 1/0
T3 1/0 is up.
Applique type is Channelized T3
No alarms detected.
MDL transmission is disabled
FEAC code received:No code is being received
Framing is C-BIT Parity, Line Code is B3ZS, Clock Source is Internal
Data in current interval (270 seconds elapsed):
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation, 0 P-bit Err Secs
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs
0 Unavailable Secs, 0 Line Errored Secs
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
Total Data (last 32 15 minute intervals):
0 Line Code Violations, 0 P-bit Coding Violation,
0 C-bit Coding Violation, 0 P-bit Err Secs,
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs,
0 Unavailable Secs, 0 Line Errored Secs,
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
• Enter the show controller t1 command and specify the slot and port numbers:
Gateway# show controller t1 1/0
T1 1/0 is up.
Applique type is Channelized T1
Cablelength is long gain36 0db
No alarms detected.
alarm-trigger is not set
Version info of slot 1: HW:768, PLD Rev:4
Framer Version:0x8
Manufacture Cookie Info:
EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x041,
Board Hardware Version 3.0, Item Number 73-4089-03,
Board Revision 05, Serial Number JAB99432626,
PLD/ISP Version 0.1,
46
Manufacture Date 11-Nov-1999.
slot/port :15—for example, interface serial 1/0:15.

Advertisement

Table of Contents
loading

This manual is also suitable for:

As5350

Table of Contents