Electrical Connection; Maintenance; Troubleshooting - Scheppach OSM100 Translation From The Original Instruction Manual

Do not overload the machine by too much pressure against
the grinding roll.
After finishing the grinding turn off the machine and dis-
connect the main plug.
ATTENTION!! Use dust mask, protective goggles and vacuum
extraction.
m Electrical connection
The installed electric motor is factory connected ready for
operation. The connection meets the applicable VDE and
DlN regulations.
The connection made by the customer as well as any ex-
tension cables used must comply with all relevant regula-
tions.
Connection and repair work on the elctric equipment must
be carried out by a qualified technician only.
Important note
The motor rating is S 1. This means that when overloaded
it switches off automatically. After a cooling period (can
vary) you may switch it on again.
m Maintenance
Disconnect the main plug before conducting any maintenance
work.
Cleaning the machine after every use is recommended.
Keep the safety devices, air boxes and the crankcase
clean.
Clean the machine with a cloth.
Do not use any solvents or cleaning agents because they
could harm the plastic parts of the device.
Do not let water get into the interior of the machine.
The interior of the machine is completely maintenance-
free.
Problem
a) ON/OFF switch damaged.
b) ON/OFF cable damaged.
c) ON/OFF relay damaged.
Motor doesn't start d) Fuse blown.
e) Motor burnt.
Machine gets slower
Too much pressure put on the workpiece.
during work.
Sanding belt comes off
Belt does not run straight.
the drive pulleys.
The wood gets burnt a) Sanding disc or belt covered with grease.
during sanding. b) Excessive pressure on workpiece.
Strong vibrations a) loosely mounted tool
b) defective tool
c) spindle knocks
Trouble shooting
Possible Cause Help
a-d) Replace all damaged parts before you use
your machine again.
e) Contact your local service centre. Every
attempt to carry out a repair, can be
dangerous if it is not done by skilled
personnel.
Reduce the pressure on the workpiece.
Reset the track.
a) Replace disc or belt.
b) Reduce pressure on workpiece.
a) tighten tool
b) change tool
c) repair at a Service-Station
english 13