Charging The Battery - Black & Decker GSBD700 Manual

Always check that the mains voltage corresponds to the
voltage on the rating plate.
Warning! Never attempt to replace the charger unit with
a regular mains plug.
Use your BLACK+DECKER charger only to charge the
u
battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
u
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/tool/battery must be placed in a well
u
$ ventilated area when charging.
The charger is intended for indoor use only.
x
Read the instruction manual before use.
The charger automatically shuts off if the ambient
temperature becomes too high. As soon as the
ambient temperature has cooled down, the charger
w will resume operating.
Fail safe isolating transformer. The mains supply is
electrically separated from the transformer output.
Electrical safety
#
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Warning! Never attempt to replace the charger unit with
u
a regular mains plug.
Features
1. On/off switch
2. Lock-off button
3. Blade release button
4. Shear blade
(Original instructions)
5. Trim blade
6. Charging indicator
Assembly
Warning! Avoid accidentally switching the tool on during
assembly.
Fitting the wall mount to the wall (fig. A & B)
The wall mount can be fitted to the wall to provide a
convenient storage and charging point for the tool.
Drive the screws in the wall through the holes in the
u
crevices of wall mount.
Place the tool on the wall mount.
u
Plug in the charger making sure the charging indicator (6)
u
lights up (fig. A).
If required, use the two pegs (7) below the wall mount to
u
store the spare blade (fig. B).
Warning! Avoid damaging the power cord when mounting the
wall mount to the wall.
Removing the charger plug from the wall mount
(fig. C)
The tool can be charged without using the wall mount. The
charger plug can be connected to the tool directly.
Remove the screws from the back of the wall mount.
u
Slide the back part (8) from the front part (9) to open the
u
wall mount.
Remove the charger plug from the wall mount.
u
Fitting and removing the blade (fig. D & E)
The shear blade (4) has been designed for trimming grass
and weeds. The trim blade (5) has been designed for trimming
hedges and shrubs.
Remove the blade cover.
u
Push and hold the blade release button (3) in the direction
u
of the arrow (fig. D1).
Slide the blade cover (10) backward and lift off (fig. D2).
u
Lower the blade onto the pins.
u
While holding the blade onto the pins (fig. E1), replace the
u
blade cover (10) and slide it forward (fig. E2).
Note: No alignment of blade with drive pin is required and
operation of the blade cover release button is not required
when re-fitting the blade cover.
Use
Warning! Let the tool work at its own pace. Do not overload.

Charging the battery

The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that were
easily done before. When charging the battery for the first
time, or after prolonged storage, it will only accept an 80%
ENGLISH
7