Charging Procedure - Black & Decker NST2118 Instruction Manual

Hide thumbs Also See for NST2118:
Table of Contents

Advertisement

Available languages

Available languages

than one extension to make up the total length, be sure each
extension contains at least the minimum wire size.
Minimum Gauge for Cord Sets
120V
0-25
Volts
Total Length of Cord in Feet
240V
0-50
More Not more
Ampere Rating
Than Than
0
-
6
18
6
-
10
18
10 -
12
16
12 -
16
14
9. Use only the supplied charger when charging your unit. The use
of any other charger could damage the battery pack or create a
hazardous condition.
10. Use only one charger when charging.
11. Do not attempt to open the charger or the unit. There are no
customer serviceable parts inside. Return to any authorized
Black & Decker service center.
12. DO NOT incinerate battery packs even if they are severely
damaged or completely worn out.
13. Do not incinerate the batteries. They can explode in a fire. A
small leakage of liquid from the battery cells may occur under
extreme usage, charging or temperature conditions. This does
not indicate a failure. However, if the outer seal is broken and this
leakage gets on your skin:
a. Wash quickly with soap and water.
b. Neutralize with a mild acid such as lemon juice or
vinegar.
c. If the battery liquid gets in your eyes, flush them with
clean water for a minimum of 10 minutes and seek
immediate medical attention. MEDICAL NOTE: The liquid
is a 25-35% solution of potassium hydroxide.
26-50
51-100 101-150
51-100 101-200 201-300
American Wire Gauge
16
16
14
16
14
12
16
14
12
12
Not Recommended

CHARGING PROCEDURE

THE BATTERY PACK IS NOT FULLY CHARGED AT THE
FACTORY. CHARGE BATTERY PACK FOR AT LEAST 9 HOURS
BEFORE USE.
The charger is designed to use standard
household 120 volt 60 Hz power.
1. Plug the charger into any standard 120
Volt 60 Hz electrical outlet (figure 1).
2. Slide the charger onto the battery pack
as shown in figure 2 and let the battery
pack charge initially for 9 hours. After
the initial charge, under normal usage,
your battery pack should be fully
charged in 6 to 9 hours.
2a) During charging the green LED will
appear.
2b) When charging is complete the green
LED will go off.
3. Unplug charger, and remove
the battery pack. Place the
battery pack into the tool
until it "clicks" into place
NOTE: To remove the battery
figure 3.
pack, press down on the
release button on the back of
the battery pack and slide out.
5
1
2
3

Advertisement

Table of Contents
loading

Table of Contents