Fein BLS1.6E Instruction Manual page 24

OBJ_BUCH-0000000109-001.book Page 23 Friday, June 7, 2013 10:26 AM
Replacing the cutter blade (BLS3.5,
BLS4.2) (figure 20).
Loosen the screw and remove the fixed
blade.
When the cutting edge of the cutter blade is
dull, turn the cutter blade by 180° and mount
back together.
When both cutting edge halves are dull,
replace the cutter blade.
Mount the fixed blade again and tighten it
with the screw.
Fig.20
4.
180 x 2
8.
Fixed blade
3.
1.
2.
Cutter
blade
4.
7.
6.
5.
Screw
Loosen the corresponding screw for the sec-
ond cutter blade.
When the cutting edge of the cutter blade is
dull, turn the cutter blade by 180° and mount
back together.
When both cutting edge halves are dull,
replace the cutter blade.
Fasten the cutter blade with the screw.
10.
Cutter
blade
11.
180 x 2
13.
14.
en
23
9.
11.
12.