Fein BLS1.6E Instruction Manual page 21

OBJ_BUCH-0000000109-001.book Page 20 Friday, June 7, 2013 10:26 AM
en
20
Turning or replacing cutting bars
(BSS1.6CE) (figure 17).
Loosen the screws with the hex key.
When the front half of the cutting edges on
the cutting bars are dull, turn the cutting bars
by 180° and mount them each to the opposite
side.
When both cutting edge halves are dull,
replace the cutting bars.
Bring the cutter blade to the cutting position.
For this, rotate the actuator clockwise a 3/4
turn.
Slide the chip cutter onto the cutter head until
the chip cutter faces against the front edge of
the cutter blade.
Hold the chip cutter and the cutting bars in
this position and fasten them with the screws.
Return the cutter blade back to the working
position by rotating the actuator counter-
clockwise.
Fig.17
Cutting bars
4.
3.
4.
3.
5.
6.
7.
Chip cutter
Chip-cutter
actuator
8.
2.
1.
Screws
2.
1.