Advertisement
Available languages
Available languages
Wheels and flanges with arbour holes
that do not match the mounting hardware of the power tool will run
out of balance, vibrate excessively and may cause loss of control.
Damaged wheels will normally break apart during this
test time.
The eye protection must be capable of
stopping flying debris generated by various operations. The dust
mask or respirator must be capable of filtrating particles generated
by your operation. Prolonged exposure to high intensity noise may
cause hearing loss.
Fragments of workpiece or of a broken
accessory may fly away and cause injury beyond immediate area of
operation.
make exposed metal parts of the power tool live and shock the
operator.
control of the power tool, the cord may be cut or snagged and your
hand or arm may be pulled into the spinning accessory.
The spinning accessory may grab the surface
and pull the power tool out of your control.
Accidental contact with the spinning accessory could snag your
clothing, pulling the accessory into your body.
draw the dust inside the housing and excessive accumulation of
powdered metal may cause electrical hazards.
Sparks could ignite these materials.
or other liquid coolants may result in electrocution or shock.
Kickback is a sudden reaction to a pinched or snagged rotating wheel.
Pinching or snagging causes rapid stalling of the rotating wheel
which in turn causes the uncontrolled power tool to be forced in the
direction opposite of the wheel's rotation at the point of the binding.
For example, if an abrasive wheel is snagged or pinched by the
workpiece, the edge of the wheel that is entering into the pinch point
can dig into the surface of the material causing the wheel to climb
out or kick out. The wheel may either jump toward or away from
the operator, depending on direction of the wheel's movement at
the point of pinching. Abrasive wheels may also break under these
conditions.
Contact with a live wire will also
If you lose
The motor's fan will
Using water
Kickback is the result of power tool misuse and/or incorrect operating
procedures or conditions and can be avoided by taking proper
precautions as given below.
control torque reactions or kickback forces, if proper precautions are
taken.
may kickback over your hand.
Kickback will propel the tool in direction
opposite to the wheel's movement at the point of snagging.
edges or bouncing have a tendency to snag the rotating accessory
and cause loss of control or kickback.
Such blades create frequent kickback and loss of control over
the power tool.
the wheel increases the loading and susceptibility to twisting or
binding of the wheel in the cut and the possibility of kickback or
wheel breakage.
and take corrective action to eliminate the cause of wheel binding.
wheel may bind, walk up or kickback if the power tool is restarted in
the workpiece.
sag under their own weight. Supports must be placed under the
workpiece near the line of cut and near the edge of the workpiece on
both sides of the wheel.
The protruding wheel may cut gas or
water pipes, electrical wiring or objects that can cause kickback.
This electronic fibercement saw can be used to cut wood or fibre
cement with a circular saw blade. It can alternatively be used to cut
stone with a diamant cutt-off wheel.
Do not use this product in any other way as stated for normal use
The operator can
Accessory
Corners, sharp
Overstressing
Investigate
The
Large workpieces tend to
English
GB
Advertisement
