Advertisement
Available languages
Available languages
Rated Input
...........................................
No-load speed ............................................
Saw blade dia. x hole dia ...............................
Diamond wheel dia. x hole dia ......................
Cutting depth at 90° ......................................
Cutting depth at 45° ......................................
Weight without cable ....................................
The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main applications of the tool. However if the tool is used for diff erent applications, with
diff erent accessories or poorly maintained, the vibration emission may diff er. This may signifi cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running
but not actually doing the job. This may signifi cantly reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the eff ects of vibration such as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
Failure to follow the warnings and instructions may result
in electric shock, fi re and/or serious injury.
Exposure to noise can cause hearing loss.
The dust produced when using this tool may be harmful to health.
Do not inhale the dust. Use a dust absorption system and wear a
suitable dust protection mask. Remove deposited dust thoroughly,
e.g. with a vacuum cleaner.
Appliances used at many diff erent locations including open air should
be connected via a residual current device (FI, RCD, PRCD) of 30mA
or less .
Always disconnect the plug from the socket before carrying out any
work on the machine.
Only plug-in when machine is switched off .
Do not use inserted tools not corresponding to the key data given in
these instructions for use.
Keep mains lead clear from working range of the machine. Always
lead the cable away behind you.
Before use check machine, cable, and plug for any damages or
material fatigue. Repairs should only be carried out by authorised
Service Agents.
Do not fi x the on/off switch in the "on" position when using the saw
hand-held.
................ 1010 W
................ 9250 min
-1
Measured values determined according to EN 60745.
...........127 x 20 mm
Typically, the A-weighted noise levels of the tool are:
........125 x 22,2 mm
Sound pressure level (K = 3 dB(A)) ................................
.................... 32 mm
Sound power level (K = 3 dB(A))....................................
.................... 28 mm
...................3,3 kg
Total vibration values (vector sum in the three axes)
determined according to EN 60745.
Vibration emission value a
sawing into wood ..........................................................
Uncertainty K= ..............................................................
cutting into stone ...........................................................
Uncertainty K= ..............................................................
the blade.
protect you from the blade below the workpiece
Less than a full tooth of the blade teeth should be visible below the
workpiece.
support the work properly to minimize body exposure, blade binding,
or loss of control.
may make exposed metal parts of the power tool „live" and shock
the operator.
This improves the accuracy of cut and reduces the chance of blade
binding.
h
If both hands are holding the saw, they cannot be cut by
Cutting accessory contacting a „live" wire
..........94 dB(A)
........105 dB(A)
........ 3,7 m/s
2
........ 1,5 m/s
2
........ 4,5 m/s
2
........ 1,5 m/s
2
GB
The guard cannot
.
It is important to
English
Advertisement
