Bosch FLYER Mountain Translation Of The Original Instruction Manual page 167

Certain versions have a preset assistan-
ce level that cannot be changed. Certain
models may also have fewer assistance
levels to choose from than are shown
here.
If the E-Bike was configured with eMTB
mode ex works, the SPORT assistance
level is replaced by eMTB. In eMTB
mode, the assistance factor and the tor-
que are adjusted dynamically depending
on the pedal force applied to the pedals.
eMTB mode is only available with Per-
formance Line CX drives.
The full range of assistance levels includes:
• OFF: motor assistance is switched off; the E-Bike
is operated like a normal bicycle through pedalling
alone. The pushing aid cannot be activated in this
assistance level.
• ECO: effective assistance with optimum efficiency
for maximum range.
• TOUR: consistent levels of assistance for tours
with large ranges.
SPORT/eMTB:
• SPORT: powerful assistance for active riding on
hilly terrain and in city traffic.
• eMTB: optimum assistance on any terrain, fast
acceleration, improved dynamics, maximum per-
formance
• TURBO: maximum assistance up to high pedal-
ling frequencies for active riding
To increase the support level, continue to press
the button «+» 13 on the operating unit until the
desired support level is displayed in field 'b'. To de-
crease the support level, press the button «–» 12.
The requested motor performance will be shown
in field 'a'. The maximum motor performance de-
pends on the electrical support level chosen.
10. Control panel
11. The display function button«i» on the
operating unit
12. Reduce assistance/scroll down button « – »
13. Increase assistance/ scroll upwards button «+»
14. Button for pushing assistance «WALK»
14
Switching the pushing/ start-up aid on and off
The pushing/ start-up aid can make it easier for
you to push the e-bike or get it moving.
FLYERS with pedalling support up to 25 km/h are
equipped with a pushing aid.
This is limited to 6 km/h in the fastest gear. The
FLYER can conveniently be moved out of under-
ground parking or along steep paths by pressing
the bicycle button 14. The bicycle button allows
models with pedalling support above 25 km/h to
activate the start-up aid, which is restricted to 18
km/h. The installation is performed in compliance
with national regulations.
To activate the pushing aid, briefly press the
«WALK» button on your on-board computer. Af-
ter activation, press the «+» button within three
seconds and hold it down. The e-bike drive will
be switched on.
The pushing aid cannot be activated in
support level «OFF».
The pushing aid is switched off as soon as one
of the following events occurs:
• You release the «WALK» 14 button,
• The wheels of the e-bike are blocked (e.g. by
breaking or bumping against an obstacle)
• speed exceeds 6 km/h or 18 km/h
With certain systems, the pushing aid
can be started directly by pressing the
«WALK» button.
165
10
13
11
12
EN