Table of Contents
Advertisement
Chapter 2
Installing the Cisco Unified Videoconferencing 3545 MCU
Changing the Configuration Software Password
You can use the serial port to change the configuration software password.
Procedure
Step 1
At the prompt, enter P to change the configuration software password and press Enter.
The user profile screen displays as follows:
At the Enter user name prompt, enter the new user name and press Enter.
Step 2
At the Enter user password prompt, enter the new password and press any key to return to the EMP Main
Step 3
menu.
Changing the Security Level
You can use the serial port to change the security level. Security levels are as follows:
•
•
•
Procedure
At the prompt, enter S to configure the network security level and press Enter.
Step 1
The security level screen displays as follows:
Enter the new security level required and press Enter.
Step 2
The updated security level screen displays as follows:
The EMP Main menu displays.
Step 3
OL-17013-01
Enter user name:
Enter new password:
0 (low)—Allows SNMP, Telnet, HTTP, FTP, and ICMP to access the MCU.
1 (medium)—Allows access to the MCU only through SNMP, HTTP and ICMP.
2 (high)—Allows only HTTP to access the MCU.
The current security level is [0 low].
Enter a new security level (0-low, 1-medium. 2-high):
The current security level is [0 low].
Enter a new security level (0-low, 1-medium. 2-high):
2
Board security level changing to [2 high]:
Set icmpRequestBlock to 2
The new security level is [2 high].
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 MCU Releases 5.6 adn 5.7
How to Perform the Initial EMP Configuration
2-25
Advertisement
Table of Contents
