Table of Contents
Advertisement
Video Processing Module Initial Configuration for the 3515 MCU
Procedure
Step 1
Access the Cisco Unified Videoconferencing 3515 MCU through the serial port and start a terminal
emulator session.
When the message "Press any key to start configuration" appears on the screen, press any key within six
Step 2
seconds.
The network configuration Main menu appears.
At the prompt, enter A to display the Advanced Configuration menu and press Enter.
Step 3
The Advanced Configuration menu appears.
At the prompt, enter 3 to select "Change LAN port Settings" and press Enter.
Step 4
At the prompt, enter the number or letter for one of the following:
Step 5
Enter this value to retain the current setting. The default setting is Auto.
Press Enter.
Step 6
The network configuration Main menu appears.
At the Network Configuration menu, do one of the following:
Step 7
Changing the Configuration Software Password
You can use the serial port to change the configuration software password.
Procedure
At the prompt, enter P to change the configuration software password and press Enter.
Step 1
The user profile screen appears as follows:
Step 2
At the Enter user name prompt, enter the new user name and press Enter.
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU24 Release 5.1
2-10
If the Cisco Unified Videoconferencing 3515 MCU is already running, you need to reboot
Note
or restart the device.
1 - 10Mbps Half Duplex
–
–
2 - 100Mbps half Duplex
–
3 - 10Mbps Full Duplex
–
4 - 100Mbps Full Duplex
5 - Auto
–
Q - Quit
–
Enter the letter for the set of parameters that you want to configure.
–
Enter Q to save your changes and allow the device to complete the boot process.
–
Enter user name:
Enter new password:
Chapter 2
Setting Up Your Cisco Unified Videoconferencing 3515 MCU
OL-11897-01
Advertisement
Table of Contents
