Table of Contents
Advertisement
Chapter 2
Installing the Cisco Unified Videoconferencing 3545 MCU
Upgrading Cisco Unified Videoconferencing 3545 MCU Software
You can perform software upgrades by using the Cisco Upgrade Utility to upload files via a network or
modem connection to the MCU. For more information, see
Upgrade Utility."
How to Perform the Initial EMP Configuration
•
•
•
•
•
•
•
•
•
About the Initial EMP Configuration
When you are working with a Cisco Unified Videoconferencing 3545 EMP, you must also perform
network configuration of this module.
Initial monitoring and administration of the EMP are performed from a remote PC using a terminal
emulation application, such as HyperTerminal. To make the serial connection, connect a PC terminal to
the front panel serial port of the EMP board as described in the
page
configuration utility to:
•
•
•
•
To enable the EMP to function properly, you must configure the EMP with a different IP address to your
Warning
MCU.
OL-17013-01
About the Initial EMP Configuration, page 2-23
Accessing the Cisco Unified Videoconferencing 3545 EMP Main Menu, page 2-24
Setting the IP Address, page 2-24
Changing the Configuration Software Password, page 2-25
Changing the Security Level, page 2-25
Pointing the EMP to the Controlling MCU, page 2-26
Changing Advanced Configuration Settings, page 2-26
Saving Network Configuration Settings, page 2-27
Connecting the EMP to the LAN, page 2-27
2-18. The serial configuration utility runs as a target configuration service. You can use the serial
Configure default network port values.
Modify the configuration software password.
Modify the MCU IP address.
Modify advanced configuration settings such as the web server port and LAN port, and to restore
the factory configuration.
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 MCU Releases 5.6 adn 5.7
How to Perform the Initial EMP Configuration
Chapter 3, "Using the Cisco Software
"Connecting to a PC" section on
2-23
Advertisement
Table of Contents
