Table of Contents
Advertisement
Chapter 2
Installing the Cisco Unified Videoconferencing 3545 MCU
For a Skinny Client Control Protocol (SCCP) environment, the IP address of the Trivial File Transfer
•
Protocol (TFTP) server or Cisco Unified Communications Manager from which you want the MCU
and EMP to get configuration information
Subnet mask for the Cisco Unified Videoconferencing 3545 MCU if applicable.
•
•
Domain Name Server and domain name for Cisco Unified Videoconferencing 3515 MCU unit if
applicable.
PC with available serial port and terminal emulator software installed, such as HyperTerminal.
•
RS-232 terminal cable (shipped with the unit).
•
Procedure
Step 1
Connect the RS-232 terminal cable to the PC terminal.
Step 2
Connect the power cable.
Step 3
Start the terminal emulation application on the PC.
Set the communication settings in the terminal emulation application on the PC as follows:
Step 4
Baud rate: 9600
•
Data bits: 8
•
Parity: None
•
Stop bits: 1
•
Flow control: None
•
Turn on the power to the MCU.
Step 5
A log of the auto-boot events appears on the computer.
When the message "Press any key to start configuration" appears on the screen, press any key within 6
Step 6
seconds.
The network configuration Main menu appears as follows:
Press any Key To start configuration...
Main menu
N: Configure default network port values
P: Change the configuration software password
S: Configure network security level
T: Configure TFTP servers list
A: Advanced configuration menu
Q: Quit
Select:
At the prompt, enter N to configure default network port values and press Enter.
Step 7
At the Enter IP address for default interface prompt, enter the IP address you want to assign to the MCU
Step 8
and press Enter.
Caution
At the Enter Default Router IP Address prompt, enter the IP address of the router associated with the
Step 9
segment in which the unit will be installed and press Enter.
OL-17013-01
Do not use leading zeros in the IP address.
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 MCU Releases 5.6 adn 5.7
How to Perform the Initial MCU Configuration
2-19
Advertisement
Table of Contents
