Table of Contents
Advertisement
Video Processing Module Initial Configuration for the 3515 MCU
Connecting the Cisco Unified Videoconferencing 3515 MCU Unit to the LAN
This section describes how to connect the Cisco Unified Videoconferencing 3515 MCU unit to the Local
Area Network (LAN).
Procedure
Step 1
Connect the supplied LAN cable from your network hub to the 10/100BaseT Ethernet port on the front
panel of the Cisco Unified Videoconferencing 3515 MCU unit. The 10/100BaseT port accepts an RJ-45
connector.
Turn on the power to the Cisco Unified Videoconferencing 3515 MCU unit.
Step 2
Video Processing Module Initial Configuration for the 3515 MCU
You must also configure an IP address for the video processing module. The IP address of the video
processing module must be different than the IP address configured for the Cisco Unified
Videoconferencing 3515 MCU unit.
Initial monitoring and administration of the video processing module are performed from a remote PC
using a terminal emulation application, such as HyperTerminal. To make the serial connection, connect
a PC terminal to the lower serial port on the front panel of the Cisco Unified
Videoconferencing 3515 MCU unit as described in the
serial configuration utility runs as a target configuration service. You can use the serial configuration
utility to:
•
•
•
•
Accessing the Video Processing Module Main Menu
You access the video processing module Main configuration menu in the same way as you access the
Cisco Unified Videoconferencing 3515 MCU unit network configuration Main menu as described in the
"Procedure" section on page
The video processing module Main configuration menu appears as follows:
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU24 Release 5.1
2-8
Configure default network port values.
Modify the configuration software password.
Modify the Cisco Unified Videoconferencing 3515 MCU unit IP address.
Modify advanced configuration settings such as the web server port and LAN port, and to restore
the factory configuration.
2-6.
Main menu
N: Configure default network port values
P: Change the configuration software password
S: Configure network security level
M: Change MCU ip address
A: Advanced configuration menu
Q: Quit
Select:
Chapter 2
Setting Up Your Cisco Unified Videoconferencing 3515 MCU
"Connecting to a PC" section on page
2-5. The
OL-11897-01
Advertisement
Table of Contents
