How To Install The Cd-Rom Drive To A Server To Which A Thick Type; Cd-Rom Drive Has Been Installed - PRIMERGY PG-DVA102D User Manual

7
Attach the covers to the server.
3.4
How to Install the CD-ROM drive to a Server
to which a thick type CD-ROM drive has
been installed
1
Connect the provided conversion DC cable to the connector of this
product.
2
Remove the covers from the server.
Refer to "Installing Options" in the "User's Guide" in the PRIMERGY Document & Tool CD
provided with the server.
3
Remove the thick type CD-ROM drive from the server.
Disconnect the interface cables and the power cables connected to the thick type CD-ROM
drive. Pull the CD-ROM with the installation rail outwards while pulling the rails attached to
the left and right and remove it.
4
Remove the rails from the thick type CD-ROM drive and attach it to
this product.
There are two types of installation rails, an installation rail that can be secured using 4
screws and an installation rail that can be secured by inserting tabs in the screw holes. When
securing this product using screws, use the provided screws for installing a 5 inch bay.
5
Install this product in the server.
Push this product into the bay that used to contain the thick type CD-ROM until a click is
heard.
Connect the interface cables and power cables removed in Step 3.
Connect the power cable to the conversion DC cable.
6
Attach the covers to the server.
44
Connect the conversion DC cable