The 00 Instruction And Program Line 00 - HP 12c User Manual

Program line 07 contains the last instruction you keyed into program memory.
However, if you press Ê again, you'll see that this is not the last line stored in
program memory:
Keystrokes
Ê
As you should now be able to tell from the keycodes displayed, the instruction in
program line 08 is gi00.
The 00 Instruction and Program Line 00
Whenever you run the program now stored in program memory, the calculator
executes the instruction in line 08 after executing the seven instructions you keyed
in. This i00 instruction — as its name implies — tells the calculator to "go to"
program line 00 and execute the instruction in that line. Although line 00 does not
contain a regular instruction, it does contain a "hidden" instruction that tells the
calculator to halt program execution. Thus, after each time the program is run, the
calculator automatically goes to program line 00 and halts, ready for you to key in
new data and run the program again. (The calculator is also automatically set to
program line 00 when you press fs to set the calculator from Program mode
to Run mode.)
The i00 instruction was already stored in line 08 — in fact, in all program
lines — before you keyed in the program. If no instructions have been keyed into
program memory, if Continuous Memory is reset, or if fCLEARÎ is pressed (in
Program mode), the instruction i00 is automatically stored in program lines 01
through 08. As you key each instruction into program memory, it replaces the
i00 instruction in that program line.
If your program should consist of exactly eight instructions, there would be no
i00 instructions remaining at the end of program memory. Nevertheless, after
such a program is executed the calculator automatically returns to program line 00
and halts, just as if there were a i00 instruction following the program.
If you key in more than eight instructions, program memory automatically expands
to accommodate the additional instructions.
File name: hp 12c_user's guide_English_HDPMBF12E44
Printered Date: 2005/7/29
Section 8: Programming Basics
Display
08- 43, 33 00
Program line 08
Page: 93 of 209
Dimension: 14.8 cm x 21 cm
93