HP zx2000 Start Here Manual page 21

Select for automatic configuration via DHCP/BOOTP.
Yes
Select to configure the network manually.
No
b. For manual configuration, you will be prompted to enter the
following: (Note that any parameters you enter manually are
purely for the purpose of retrieving the image from the server
and will not be reflected in the final system configuration.)
1. Hostname for your machine
2. Domain for your machine
3. IP address for the name server for your network
4. IP address for the machine you are installing on
5. Netmask for your network
6. Broadcast address for your network
7. Default gateway address for your network
8. IP address for the SystemImager server
9. Name of the image you wish to use, or leave blank to use the
default.
c. Confirm your network parameter selections when prompted.
Your system attempts to contact the image server, boots into a
restore kernel, gets disk partition information from the
SystemImager server, partitions the disk drive, and places
21