HP xw6000 Installation Information page 5

To maintain Class B standards for radiated emissions, SATA cables on HP Workstation xw6000
systems must be routed so they do not contact the access panel. Loosely tie-wrap the SATA cables to
the audio cable as shown in the following illustrations
HP Workstation xw6000 cable routing (shown with a standard graphics card)
HP Workstation xw6000 cable routing (shown with AGP support bracket)
7. Connect the power cable to each drive.
8. Close the access panel.
9. Reconnect the main power cord to the rear of the workstation and to the electrical wall outlet.
5