Table of Contents
Advertisement
OPERATING THE DVI DETECTIVE PLUS
Writing an EDID using a source device/signal generator
The DVI Detective Plus allows a signal generator (or other source device) to write
an EDID to the Detective. This provides additional flexibility when programming
custom timings and refresh rates.
1.
Make sure that the write-protect switch on the DVI Detective Plus is in the
"D" (disable write-protect) position and make sure all DIP switches are in the
OFF (down) position.
2.
Use an DVI cable to connect the source (generator) device to the DVI In port
on the DVI Detective Plus.
3.
Connect the included 5V DC power supply to the DVI Detective Plus.
4.
Use the source (generator) device to send the EDID data to the DVI
Detective Plus.
9
Advertisement
Table of Contents
