Restoring The Software - HP xw4100 Getting Started Manual

Software Setup
CAUTION: After the automatic installation has started, DO NOT
TURN OFF THE WORKSTATION UNTIL THE PROCESS IS COMPLETE.
Turning off the workstation during the installation process may
damage the software that runs the workstation or prevent its proper
installation.
NOTE: After you have selected a language during initial boot of the
OS, the language will be locked in by the UIA sector of their HDD. If
the system is restored for some reason, the restore CD will check for the
language stored in the UIA and will restore only the original preinstalled
language. In the case where a new HDD is installed and the there is no
UIA or the UIA is empty, then the Recovery CD will install any
language requested. If the wrong OS is accidently unbundled during the
initial boot, technical support will have to be contacted to get a "key" to
unlock it and then you will be able to restore the OS to the correct
language.
For complete operating system installation and configuration
instructions, refer to the operating system documentation that was
provided with the workstation. Additional information is available in the
online help after you install the operating system.

Restoring the Software

Restore the original operating system and factory-installed software by
using the Restore Plus! CD and the OS CD that came with the
workstation. Carefully read and follow the instructions provided with
the Restore Plus! CD.
NOTE: If you restore your system using the Restore Plus! CD, some
settings, such as your power management settings (such as the
Energy Star® settings) will need to be reapplied.
2–2 www.hp.com Getting Started Guide