Opticon OPN-2005 Manual page 8

Bluetooth Application Quick Setup - Guide
Book as well. After scanning each number of the PIN code, scan the END label to send the PIN code to the remote
device.
When executed correctly your device should now be connected and you should be allowed to scan and transmit
barcodes into any document or application that accepts keyboard input. If the remote device does establish the
pairing, but doesn't automatically connect, you might have to manually connect afterwards by pressing the trigger
key for 5 seconds.
To manually end a connection you can press the clear key for 5 seconds to disconnect your device.
If you've lost your connection, then your device will try to reconnect automatically for about 1 minute, but if that
fails you can reconnect manually by pressing the trigger key for 5 seconds. The trigger key allows you to reconnect
without having to enter the PIN code again as long as the remote device doesn't lose the pairing information and the
Bluetooth companion scanner wasn't reset to default (or the remote Bluetooth address wasn't changed).
If the pair was ever lost or you want to connect to another remote device you will have use the clear key again to
make your device connectable and allow the remote device to connect and pair with it.
8