Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for Opticon PHL 2700
Summary of Contents for Opticon PHL 2700
- Page 1 User’s Manual Laser Terminal PHL 2700 Cradle IRU 2700...
-
Page 2: Table Of Contents
6.1.4 Functionality bar code labels at varying distances. In no event, Opticon Sensors Europe will be liable for 6.1.5 Environmental specifications ANDLING PRECAUTIONS any direct, indirect, consequential or incidental dam- 6.1.6... -
Page 3: Installation
Cable for cradle Handstrap Cable for terminal RS485 network cable 14. Electrical contacts RS232 cable for power supply from the cradle IRU2700 to terminal 15. RS-232C connector for connecting external device, or for system expansion, through Opticon RS232 cable Opticon user's manual... -
Page 4: Display Of Terminal
1. DC input socket input for AC adaptor 2. RS 485 socket for connecting another cradle in multi-drop RS485 network, through Opticon RS485 cable Description of the display indicators 3. RS 232 C socket for connecting to PC or modem, through... -
Page 5: Handling Precautions
Do not use water when cleaning the cradle. instructions in the next chapter. appendix, please consult our service This can cause malfunction in the chargers. Click the battery pack into the terminal, department. as instructed in the next chapter. Opticon user's manual... -
Page 6: Installing, Replacing And Charging Batteries
Dry cel Opticon batteries (Alkaline). (new) batteries, please make sure you are batteries is inserted in the terminal, it will To be used together with Opticon battery Never remove the main battery pack using the recommended batteries. not be charged by the cradle. -
Page 7: How To (Re)Place The Main Battery In The Terminal
Than press the pack tight into the housing untill it cliks (ref. 4) Fit cover: Place the battery case cover and lock the switch (shift to the left) (ref. 1) Opticon user's manual... -
Page 8: Installing In A System
2.6.1 Terminal to computer 2.6.4 DIP switch settings on cradle 2.6 INSTALLING IN A SYSTEM Setting the DIP switches on or off will result in PHL 2700 differrent baudrates and enabled or disabled HOST functions of the cradle. Exercise caution at all times when working with AC-powered equipment. -
Page 9: Scanning
When the read is incorrect you can try again, 6 + 1 not used ON (fixed) paying attention to the instructions in this not used chapter. Opticon user's manual... -
Page 10: Specifications
PC UPC-A incl. +2,+5 automatically. via cable, com port or IrDA. UPC-E incl. +2,+5 Charging method Rechargeable Ni-MH pack in Interfaces supported RS232 by direct cable terminal via cradle RS232 by cradle IrDA on terminal Opticon user's manual... -
Page 11: Troubleshooting
The backup battery is empty. number is still present. If sending the terminal Replace the Lithium CR2032 battery by or cradle, please use the original packing to a new one. minimise the chances of damage. Opticon user's manual... -
Page 12: Terminal Problems
Terminal IRU2700-S O2540000015 Disconnect the battery pack, and place it Send the terminal to your supplier for service, PHL 2700-80 (8MB) A73800R0040 then back in. paying attention to the limited warranty. Power supply for cradle The terminal will be in off-state. - Page 13 Opticon Article Code O0220000022 Opticon user's manual...