4.12 Rfgo-A22 Control Box - Riello RS 810/M BLU Modulating Operation

4.12 RFGO-A22 control box

Warnings
To avoid accidents, material or environmental
damage, observe the following instructions!
The control box is a safety device! Avoid opening
WARNING
or modifying it, or forcing its operation. Riello
S.p.A. cannot assume any responsibility for dam-
age resulting from unauthorised interventions!
 All interventions (assembly and installation operations,
assistance, etc.) must be carried out by qualified personnel.
 Before modifying the wiring in the control box connection
area, fully disconnect the system from the power supply
(omnipolar separation). Check the system is not powered
and cannot be accidentally reconnected. Failure to do this
will lead to the risk of electrocution.
 Protection against electrocution from the control box and all
connected electric components is obtained with the correct
assembly.
 Before any intervention (assembly and installation opera-
tions, assistance, etc.), ensure the wiring is in order and that
the parameters are correctly set, then make the safety
checks.
 Falls and collisions can negatively affect the safety func-
tions.
In this case, the control box must not be operated, even if it
displays no evident damage.
For the safety and reliability of the control box, comply with the
following instructions:
– avoid conditions that can favour the development of conden-
sate and humidity. Otherwise, before switching on again,
make sure that the entire control box is perfectly dry!
– Static charges must be avoided since they can damage the
control box's electronic components when touched.
Technical description of the burner
13 GB
Technical data
Mains voltage
Mains frequency
Primary fuse (external)
Weight
Power absorption
Protection level
Safety class
Environmental conditions:
Operation
Mechanical conditions
Temperature range
Humidity
Mechanical structure
The control box is made of plastic to resist knocks, heat and
flame propagation.
The electronic flame signal amplifier is integrated into the control
box.
20152163
AC 230 V -15 % / +10 %
50 / 60 Hz
max. 10 A
approx. 1 kg
approx. AC 3.5 VA
IP40
II
DIN EN 60721-3-1
Class 1K2
Class 1M2
-40...+60 °C
< 95 % r.h. (without condensing)
20163413
Fig. 7
Tab. F