Advertisement
OPENING AND CLOSING THE PIPE HOOK
A Press the locking plate and snapper one after
another.
B Attach the pipe hook to the anchor point.
ATTENTION:
The FS92 is approved as an anchor connector
(EN 362, Class A) and should therefore only be
used on the anchor point.
C After the locking plate and snapper are
released, they close automatically, unless an
object (harness strap or similar) block the
closing process.
CAUTION: RISK TO LIFE!
Check that the locking plate and snapper are
closed!
CAUTION: RISK TO LIFE!
If the locking plate and snapper cannot be
closed on an anchor point, this pipe hook may
not be used for this anchor point!
CAUTION: RISK TO LIFE!
Application situations in which pressure would
be exerted onto the locking plate and snapper
(e.g. weight on the pipe hook, clamping of the
pipe hook, application situations in tight
spaces) are not allowed for the pipe hook. For
these kinds of application situations, connec-
tors with a 3rd lock (e.g. TL+ karabiner, FS51/SG)
should be used to prevent unintentional
opening of the lock!
FS92 IN USE
A
C
B
EN
Advertisement
