Comfort Adjustment; Tiller Angle Adjustment; Seat Rotation Adjustment; Armrest Width Adjustment - Pride Mobility APEX ALUMALITE Owner's Manual

Lithium battery
Table of Contents

Advertisement

V. C O M F O R T A D J U S T M E N T S
TILLER ANGLE ADJUSTMENT (See figure 23)
WARNING! Remove the key from the key switch
before adjusting the tiller or the seat. Never
attempt to adjust the tiller or the seat while the
Travel Scooter is in motion.
WARNING! Prior to operating the scooter, push
and pull on the tiller to ensure that the angle
adjustment mechanism is secure. Inspect the
tiller adjustment knob and the angle adjustment
mechanism to ensure that they are fully
engaged. If there is movement in the tiller,
check to make sure that the tiller adjustment
knob is fully tightened.
NOTE: In order to fully lower the tiller, you must first remove
the seat and battery pack. Remove the seat by pulling it straight
up and off of the Travel Scooter.

SEAT ROTATION ADJUSTMENT

The seat rotation lever, located on the right side of the seat base,
secures the seat into several positions. See figure 24.
1. Pull up on the seat rotation lever to disengage the seat.
2. Rotate the seat to the desired position.
3. Release the lever to secure the seat into place.

ARMREST WIDTH ADJUSTMENT

The armrest width can be adjusted inward or outward.
1. Loosen the armrest adjustment knobs. See figure 24.
2. Use the attached ring to pull and remove the detent pins.
3. Slide the armrests in or out to the desired width.
4. Align the adjustment holes on the seat frame and armrest,
then reinsert the detent pins.
5. Tighten the armrest adjustment knobs.
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to different heights. See figure 25.
1. Remove the seat and battery pack from your Travel Scooter.
2. Use the attached ring to pull and remove the detent pin from
the lower seat post.
3. Raise or lower the upper seat post to the desired seat height.
4. While holding the upper seat post at that height, align the
adjustment holes of the upper and lower seat posts.
5. Fully insert the detent pin.
6. Replace the battery pack and seat.
Apex Alumalite
Figure 23. Tiller Adjustment Knob
IDENTIFICATION KEY
Armrest Adjustment Knobs
Detent Pins
Seat Rotation Lever
Figure 24. Seat Adjustments
IDENTIFICATION KEY
Upper Seat Post
Lower Seat Post
Detent Pin
Figure 25. Seat Height Adjustment
20

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents