Installation - Royal Sovereign ARP-2208 Manual

INSTALLATION

The air conditioner requires being vented outside so that the exhaust air can escape the room. Do
not replace or extend exhaust hose beyond its specification. This will result in decreased efficiency
of the unit and may cause the unit to shut down due to low backpressure.
STEP 1: Connect the hose connector to one end of the exhaust hose.
STEP 2: Connect the windows kit adapter to the other end of the exhaust hose.
STEP 3: Extend the adjustable window kit the length of your window. Connect the exhaust hose to
the window kit. The window kit can be installed either horizontally or vertically.
The window kit can be adjusted from 25.6"-47.2" (0.65-1.2m).
The exhaust hose can be adjusted from 9.4"-59" (240-1500mm).
STEP 4: Open the window and place the window kit on the inside edge of the window. Adjust the
window seal plate to the width of the window. Once secure, close the window to secure it
in place.
Note : Depending on the type of window frame, for some window installations the use of duct tape
may be ideal to better seal the window kit to attain a better closed seal which will yield
maximum efficiency.
-6-
ARP-2208