Troubleshooting - Bosch VitaPower 8 Series Instruction Manual

Troubleshooting

In the following table you will find solutions for problems or faults which you can easily
rectify yourself. If a fault cannot be eliminated, please contact customer service.
Problem
Appliance fails to
start up or switches
off while in use. The
symbol lights up.
Vacuum pump is
running but the
preset vacuum level
is not reached. The
symbol lights up
and 2 short signal
tones sound.
Vacuum pump not
running or switches
off while in use. The
symbol lights up.
Appliance fails to
start up or switches
off while in use.
Possible cause
Blender jug is not
correctly positioned
or has become
detached.
The cap is not closed
properly.
Lid or vacuum seal is
soiled or damaged.
Lid is not fitted
properly / completely.
The cap is not closed
properly.
Seal of blade
insert is soiled or
damaged.
Blade insert is not
fitted properly /
completely.
Moisture in vacuum
unit
Max. capacity
exceeded
The overload
protection device is
activated.
Remedial action
Fit the blender jug and lid properly.
Press cap right down.
■ Switch off the appliance.
■ Check lid, vacuum seal and seal of
blade insert for damage.
■ Clean and dry thoroughly and then
replace.
■ Rotate the blade insert in the blender
jug to the stop. Observe the marking.
■ Fit the lid correctly and press on firmly.
Observe the recess on the handle when
doing so.
■ Press cap right down.
■ Switch on the appliance and try again.
Remove vacuum valve. Clean and dry the
vacuum valve and cap thoroughly.
Depending on the ingredients, do not fill
beyond the relevant
blender jug when filling.
■ Set the rotary selector to 0. Wait until
the appliance comes to a standstill.
■ Switch off the appliance using
Disconnect the mains plug.
■ Let the appliance cool down for approx.
15-20 minutes and then switch it on
again.
■ If the appliance still does not start, leave
the appliance to cool down further and
try it again later.
Troubleshooting
marking on the
button.
en
31