Partner SP-850-S Service Manual page 25

Change Settings
This item allows you to specific IO address and IRQ for the parallel port.
Device Mode
This item allows you to set the data transfer protocol for the parallel port. There are four options:
Standard Parallel Port Mode, EPP Mode (Enhanced Parallel Port), ECP Mode(Extended Capabilities
Port), and ECP & EPP Mode. The default setting is Standard Parallel Port Mode. Extended
Capabilities Port (ECP) and Enhanced Parallel Port (EPP) are bidirectional modes, allowing both data
input and output. ECP and EPP modes are only supported with EPP- and ECP-aware peripherals.
Serial Port x Voltage select
Serial Port x Voltage select
This item allows you to set voltage for a serial port.
Hardware Monitor
25