Complete The Questionnaire To Check Your Understanding - HP Vectra VE6 8 Supplementary Manual

Complete the Questionnaire to Check Your Understanding

Draw a circle around each letter that corresponds to a correct answer.
(There may be more than one correct answer to each question).
1 Can you use a non-Ultra ATA cable with an Ultra ATA device?
a Yes, you can use a non-Ultra ATA cable with an Ultra ATA device.
b No, you must use an Ultra ATA cable with an Ultra ATA device.
2 During the flashing of the BIOS, there is a power failure. How can the
system be recovered?
a Restart the PC and try flashing the BIOS again.
b Use the Crisis Recovery procedure to restore the contents of the
corrupted EEPROM.
c Toggle switch 5 to the ON position and restart the PC.
3 After changing the order of the IDE hard disk drive on the IDE cable,
nothing is changed in the
you explain why?
a The configuration data stored in the EEPROM is corrupt.
b The IDE cable is not connected correctly to the disk drives.
c The boot order is not determined by the physical location of the IDE
hard disk on the IDE cable.
4 What must you check before you change the system board?
a Check that the latest driver versions are installed.
b Check that the latest BIOS has been flashed.
c Check that the problem you are trying to solve isn't described in the
product bug-list.
d Check that you are electrostatically grounded.
5 What type of BIOS is in the Vectra VE series 8?
a A non-modified Phoenix BIOS.
b An AMI BIOS with full DMI 2.0 support and all HP extensions.
c A standard AMI BIOS with DMI 2.0 support.
d It doesn't matter, you can use any of the above.
Complete the Questionnaire to Check Your Understanding
Advanced CMOS Setup
Boot Device list. Can
25