Synchronizing The Wireless Keyboard Or Mouse - HP TouchSmart dx9000 Reference Manual

Synchronizing the wireless keyboard or mouse

The wireless keyboard and mouse are pre-synchronized for your convenience, to work with your HP
TouchSmart PC. They should work immediately after pulling the battery tabs, which activate the pre-
installed batteries, and turning the mouse switch on (B).
You may need to manually synchronize the wireless keyboard or mouse if they are not functioning.
To synchronize them:
●
Make sure the keyboard and mouse are next to the HP TouchSmart PC, within 30 cm (1 foot) and
away from interference from other devices.
●
Keyboard: Press the connect button on the bottom of the keyboard (A) for five seconds. The blue
activity LED in the bottom rear of the HP TouchSmart PC will illuminate when the synchronization
command has been received and will go off when synchronization is complete.
● Mouse: Press the connect button on the bottom of the mouse (C) for five seconds. The blue activity
LED in the bottom rear of the HP TouchSmart PC will illuminate when the synchronization
command has been received and will go off when synchronization is complete.
If this does not work, remove and then reinsert the wireless keyboard and mouse receiver from the back
of the computer and then synchronize the keyboard and mouse again.
36 Chapter 3 Removal and Replacement Procedures